NEW TO MEGASUIRT need help/advice
-
- MegaSquirt Newbie
- Posts: 6
- Joined: Thu Feb 21, 2008 3:00 pm
- Location: mallabula near newcastle nsw
NEW TO MEGASUIRT need help/advice
i am trying to work out how to adjust/play with it have down loaded several programs that were recomended but to tell the honest truth im lost
cant work it out
is there any body in newcastle nelson bay area who would like to give some insite as to how this all works
rod
Do you know what version Megasquirt you have? and what version Firmware it is using? or Can the previous owner/installer give you these details?
If you can't answer those questions then a good start would be if you could take the lid of the MS and take a photo of the inside and post it here.
The tuning program you want is "Megatune" version 2.25. But it needs to be set up with the correct settings to suit what version Megasquirt and firmware you have. Once you can tell us what versions you have it should be pritty easy to help you set it up. I just helped a mate set his laptop up over the phone last night.
Cheers
Daniel
LS3 powered Race boat with MS3pro and GPIO.
MS2 on a 22r in a Hilux (mates car).
MS2extra on a turbo EF Falcon (brothers car).
Toyota Supra 1jz MS2extra, COP.
13B Turbo MS2extra.
-
- MegaSquirt Newbie
- Posts: 6
- Joined: Thu Feb 21, 2008 3:00 pm
- Location: mallabula near newcastle nsw
new to megasquirt
i cant ask the last owner as i rescued the car of the back of a tilt tray on its way to be scrapped he neither new or cared
the car is a sdi rover 3500 v8 1982 manual
rod
Cheers
Daniel
LS3 powered Race boat with MS3pro and GPIO.
MS2 on a 22r in a Hilux (mates car).
MS2extra on a turbo EF Falcon (brothers car).
Toyota Supra 1jz MS2extra, COP.
13B Turbo MS2extra.
-
- MegaSquirt Newbie
- Posts: 6
- Joined: Thu Feb 21, 2008 3:00 pm
- Location: mallabula near newcastle nsw
Re: NEW TO MEGASUIRT need help/advice
i sorted it out fairly well i found the map sensor to be full of water how this happened i dont know i blew it out and cleaned it with electrical cleaner and most of my flat spot went away i did some reaserch and found that the ecu was a reinstall from another car and hey had not fitted the oxy sensor at this point i got an offer on the car to good to refuse $2000 which was 2 times what it owed me so i sold it .
now i am driving as a worktruck a 1982 FJ60 landcruiser with aninjected 302 which i want meggasquirt as i am not happy withthe factory set up (cant stop it running rich on petrol ) but thats life the poor ecu and set up is so bastardised that it wont come out of limp home mode which also means that the timing is locked as well as it is ecu contolled.
well im gunna start a new post about the 4x4
se ya
rod
-
- Helpful Squirter
- Posts: 61
- Joined: Fri Mar 11, 2005 10:30 pm
- Location: Qld, Australia
Re: NEW TO MEGASUIRT need help/advice
Looking forward to it Ron!