Wanted: throttle bodies
-
- Helpful Squirter
- Posts: 61
- Joined: Fri Mar 11, 2005 10:30 pm
- Location: Qld, Australia
Wanted: throttle bodies
I'm after something off a bike but will consider anything. Give me a shout if you have some, or know of some.
Damo.
Re: Wanted: throttle bodies
LS3 powered Race boat with MS3pro and GPIO.
MS2 on a 22r in a Hilux (mates car).
MS2extra on a turbo EF Falcon (brothers car).
Toyota Supra 1jz MS2extra, COP.
13B Turbo MS2extra.
Re: Wanted: throttle bodies
What engine will they be going on?
-
- Helpful Squirter
- Posts: 61
- Joined: Fri Mar 11, 2005 10:30 pm
- Location: Qld, Australia
Re: Wanted: throttle bodies
I've just been looking on there, and even with the ordinary exchange rate I can probably get something pretty reasonably priced. The only problem with these is the throttle bore is probably a little bigger than i'd like, but at the end of the day I don't think it's going to make much difference.devojet wrote:There are always cheap sets on ebay US. But now with the aus dollar so low they aren't so cheap. Do a search for GSXR throttles, they seem to be the most flexable for use on other engines.
I was hoping to get the whole assembly including fuel rails etc. complete, I want to keep the fabrication to a minimum as i've already got enough stuff to do for this one! It's going on a Suzuki GTi engine (1300cc) with a Baleno SOHC 16v head + supercharger.long283 wrote:How about four stromburg butterfly/throttle assemblies or something similar? (the throttle assembly unbolts from the rest of the carb) With a 10kohm pot on one end for TPS. The early holden sixes had the smaller throttle bore.
What engine will they be going on?